Sale
  • Moki Corsair/ AT6 etc Style 2inch Prop Hub set For S215, S250, S300 - predrilled
  • Moki Corsair/ AT6 etc Style 2inch Prop Hub set For S215, S250, S300 - predrilled
  • Moki Corsair/ AT6 etc Style 2inch Prop Hub set For S215, S250, S300 - predrilled
  • Moki Corsair/ AT6 etc Style 2inch Prop Hub set For S215, S250, S300 - predrilled

Moki Corsair/ AT6 etc Style 2inch Prop Hub set For S215, S250, S300 - predrilled

This Scale Moki Prop Hub Set is for your Moki S215, S250, S250-7 and S300 projects, cut from aluminum and hollow on the inside.

The included backplate will replace your Moki Prop Washer plate. You simply bolt it down just as you would bolt down the Moki Prop Washer Plate using the 6 M5 bolts, then place the spinner hub on top of it and use the included center bolt to install. Done.

 

Keep in mind, this set is meant "one size fits all".

Your propeller's hub area should be of a minimum diameter of 60mm or 2.35 inches (and most if not all props will be for the S215 and above),

Your propeller's hub should be at least 52mm or 2 inches thick, otherwise you would have to drill out the mounting plate a bit, which all it takes is a drill.

 

Note: please make sure to tighten down all 6 prop bolts evenly. Should you have tightened one side of the prop washer plate down firmer than the opposing side the plate will be positioned "not flat to the motor".  The prop hub will slightly "wobble". Simply stop the motor, tighten the opposing side and the wobble will stop. It helps to mark with a Sharpie one side of the washer plate in order to identify sides.